Crate TXB50 Specifications download pdf (Page 6)

6

THE

FRONT PANEL:

1. INPUT: Connect an active or passive

instrument here by means of a shield-

ed signal cable terminated with a 1/4”

connector.

2. GAIN: Use this control to adjust the

input signal level for the best signal to

noise ratio without distortion.

3. CONTOUR: This control is only

active when the Contour Active switch

(#4) is depressed. Use this control to

vary the position of the contour effect.

This control gives you a wide variety of

tone variations, from a studio “V”-

shaped tone to a more “live,” more

present sound.

4. CONTOUR ACTIVE: This switch,

when depressed, activates the

Contour control (#3).

5. LOW: Use this control to adjust the

low frequency level of the amplifier.

This control provides a 19dB range of

cut or boost at 60Hz.

6. LOW MID: Use this control to adjust

the lower-midrange frequency level of

the amplifier. This control provides a

25dB range of cut or boost at 200Hz.

7. HIGH MID: Use this control to

adjust the upper-midrange frequency

level of the amplifier. This control pro-

vides a 16dB range of cut or boost at

1kHz.

8. HIGH: Use this control to adjust the

high frequency level of the amplifier.

This control provides a 28dB range of

cut or boost at 10kHz.

TXB50

ACTIVE

EQUALIZATIONINPUT

GAININPUT CONTOUR LOW LOW HIGH

MID MID

HIGH

–12 +12 –12 +12 –12 +12 –12 +12

1 2 3 5 6 7 84

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments